You are here
WL0003 - WLC Basic Installation (Part 1)
Difficulty Level:
Lab Document:
<Please login to see the content>
Category:
Wireless
Video Download:
Title: WL0003 - Video Download $11.00
The video walks you through three different methods of installing and initializing Cisco Wireless LAN Controller. We will start by using a Command Line Interface (CLI) which is known to work well and supported on all controller platforms. With recent software releases, you also have an option to perform initialization via GUI and we will demonstrate this over both wire and wireless. This is also known as WLAN Express Setup on Cisco 2504 with best-practices and configuration optimization built-in.
Part 1 of the video covers controller initialization via CLI
Topic:
- Cisco 2504 Wireless LAN Controller
- Controller Initialization via CLI
- Controller Initialization via GUI on Wire
- Controller Initialization via GUI over Wireless
- WLAN Express Setup
About Author
Metha Chiewanichakorn, CCIE#23585 (Ent. Infra, Sec, SP), is a Cisco networking enthusiast with years of experience in the industry. He is currently working as a consulting engineer for a Cisco partner. As a founder of and an instructor at labminutes.com, Metha enjoys learning and challenges himself with new technologies.
3 comments
Switch interfaces 1/0/5 and 1/0/6
Hi
Initially configured @ the beginning, there is only 1 interface from WLC (port 1) to Switch (1/0/5).
Why @ the end of the lab, there are two interfaces configured from WLC to switch?
Thanks,
Shady
Switch interfaces 1/0/5 and 1/0/6
The video only shows configuration for 1/0/5. 1/0/6 will be used in the future lab for interface redundancy.
Hello!
Great video!!,
I am wondering how you establish the link connection between SW1 and the Internet, did you use a PAT with a single access list for each vlan to translate and using each vlan interface?
Are you pointing with default route to the 192.168.10.1?
Thank you =)