Over 400 of free Cisco lab videos with complete step-by-step

SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 2)

The video shows you how to configure Cisco NGIPSv (aka Firepower Virtual Sensor)into IDS and IPS mode on Cisco UCS-E. We have a UCS-E installed on a branch router and we will start by sending copy of traffic to it (ie. IDS). We will then place the sensor logically inline (ie. IPS) by using two different methods.

Rating:

Average: 5 (1 vote)

Difficulty Level:

Tag:

Read more about SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 2)
Log in or register to post comments

SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 1)

The video shows you how to configure Cisco NGIPSv (aka Firepower Virtual Sensor)into IDS and IPS mode on Cisco UCS-E. We have a UCS-E installed on a branch router and we will start by sending copy of traffic to it (ie. IDS). We will then place the sensor logically inline (ie. IPS) by using two different methods.

Rating:

Average: 5 (2 votes)

Difficulty Level:

Tag:

Read more about SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 1)
2 comments
Log in or register to post comments

RS0075 - UCS-E ESXi Installation

The video demonstrates an installation of VMware ESXi 5.5 on Cisco UCS-E. We will utilize the virtual KVM and virtual media to perform installation. Basic networking will be configured. We will have an operational ESXi install by the end of the video.

Rating:

Average: 5 (1 vote)

Difficulty Level:

Tag:

Read more about RS0075 - UCS-E ESXi Installation
Log in or register to post comments

SEC0159 - ASA FirePower FireSight System Installation

The video walks you through an installation procedure for Cisco FireSight System virtual appliance, and system configuration wizard to setup basic network parameters. We will have access to the FireSight web interface at the end of this video. Familiarity with VMware ESXi is recommended.

Rating:

Average: 5 (6 votes)

Difficulty Level:

Tag: