View Cart
0 Items | Total: US$0.00
Welcome,      Register

You are here

ids

SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 3)

The video shows you how to configure Cisco NGIPSv (aka Firepower Virtual Sensor)into IDS and IPS mode on Cisco UCS-E. We have a UCS-E installed on a branch router and we will start by sending copy of traffic to it (ie. IDS). We will then place the sensor logically inline (ie. IPS) by using two different methods.
Rating: 
5
Average: 5 (2 votes)
Difficulty Level: 
0

SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 2)

The video shows you how to configure Cisco NGIPSv (aka Firepower Virtual Sensor)into IDS and IPS mode on Cisco UCS-E. We have a UCS-E installed on a branch router and we will start by sending copy of traffic to it (ie. IDS). We will then place the sensor logically inline (ie. IPS) by using two different methods.
Rating: 
5
Average: 5 (1 vote)
Difficulty Level: 
0

SEC0236 - FTD 6.1 NGIPSv IDS and IPS Modes (Part 1)

The video shows you how to configure Cisco NGIPSv (aka Firepower Virtual Sensor)into IDS and IPS mode on Cisco UCS-E. We have a UCS-E installed on a branch router and we will start by sending copy of traffic to it (ie. IDS). We will then place the sensor logically inline (ie. IPS) by using two different methods.
Rating: 
5
Average: 5 (2 votes)
Difficulty Level: 
0

WL0031 - WLC Rogue Detection and IDS (Part 4)

The video discusses a topic of rogue device detection on Cisco Wireless LAN Controller. We will demonstrate how a rogue is detected, using Monitor Mode AP and WSM, and determined if it is connected to your corporate network. We will go through configuration of rogue classification and containment. The video closes with overview on wireless IDS. Wireshark captures are taken throughout the video to provide you with insight into protocol behavior. 
Rating: 
0
No votes yet
Difficulty Level: 
3

WL0031 - WLC Rogue Detection and IDS (Part 3)

The video discusses a topic of rogue device detection on Cisco Wireless LAN Controller. We will demonstrate how a rogue is detected, using Monitor Mode AP and WSM, and determined if it is connected to your corporate network. We will go through configuration of rogue classification and containment. The video closes with overview on wireless IDS. Wireshark captures are taken throughout the video to provide you with insight into protocol behavior. 
Rating: 
0
No votes yet
Difficulty Level: 
3

WL0031 - WLC Rogue Detection and IDS (Part 2)

The video discusses a topic of rogue device detection on Cisco Wireless LAN Controller. We will demonstrate how a rogue is detected, using Monitor Mode AP and WSM, and determined if it is connected to your corporate network. We will go through configuration of rogue classification and containment. The video closes with overview on wireless IDS. Wireshark captures are taken throughout the video to provide you with insight into protocol behavior. 
Rating: 
0
No votes yet
Difficulty Level: 
3

WL0031 - WLC Rogue Detection and IDS (Part 1)

The video discusses a topic of rogue device detection on Cisco Wireless LAN Controller. We will demonstrate how a rogue is detected, using Monitor Mode AP and WSM, and determined if it is connected to your corporate network. We will go through configuration of rogue classification and containment. The video closes with overview on wireless IDS. Wireshark captures are taken throughout the video to provide you with insight into protocol behavior. 
Rating: 
0
No votes yet
Difficulty Level: 
3
Subscribe to RSS - ids