View Cart
0 Items | Total: US$0.00
Welcome,      Register

You are here

Home » Routing and Switching » RS0118 - SDA LAN Automation with PnP (Part 2)

RS0118 - SDA LAN Automation with PnP (Part 2)

Rating: 
5
Average: 5 (1 vote)
Difficulty Level: 
0
Lab Document: 
<Please login to see the content>
Category: 
Routing & Switching
Video Download: 
Title: RS0118 - Video Download $17.00
Purchase RS0118 - Video Download $17.00
The video walks you through a configuration process to perform LAN automation on Cisco DNAC. We will bring up an underlay network of four switches by manually configuring just a seed device, while the remaining switches will be automatically brought up using PnP. The goal is to demonstrate a potential time saving of using LAN automation in a large SDA deployment.
 
Part 2 of this video covers switch bring-up with PnP
 
Topic:
  • LAN Automation
  • Seed Device
  • IP Address Pool
  • ISIS Underlay Routing
Tag: 
sda
dnac
pnp
isis
dhcp
automation

About Author

Metha Chiewanichakorn, CCIE#23585 (Ent. Infra, Sec, SP), is a Cisco networking enthusiast with years of experience in the industry. He is currently working as a consulting engineer for a Cisco partner. As a founder of and an instructor at labminutes.com, Metha enjoys learning and challenges himself with new technologies.
http://www.linkedin.com/in/methachiewanichakorn

6 comments

Submitted by krnlpanic on Thu, 02/13/2020 - 08:40

So would you use a different downstream seed device if you needed to do more switch additions via LAN automation? Also can you change the hostname after it finishes to something more recognizable?
Your videos are a great help, thank you for providing them.

Submitted by admin on Sun, 02/23/2020 - 22:21

Your seed device always have to be at the edge of the network where your next Edge node will connect to. Hostname can be changed on the devices themselves afterward and do re-sync from DNAC.

Submitted by technoit on Fri, 03/20/2020 - 09:47

Very helpful videos
How do you telnet to the devices while they have blank config?

Submitted by divakar429 on Fri, 07/10/2020 - 00:08

if I am doing a LAN automation for greenfield devices, then it will add into the inventory at finally. in this case, fabric provision will happen or not, I mean LISP configuration for overlay. Lan automation is completely for device provision or both device provision and fabric provisioning.

Submitted by divakar429 on Fri, 07/10/2020 - 00:11

I can see the DHCP pool on seed device for Vlan 1 when I started LAN automation. But while discovering the new devices, I can see the IP address on Loopback interfaces on PnP agents. Could you please confirm on which interface the IP will assign on PnP devices.

Submitted by divakar429 on Fri, 07/10/2020 - 00:12

After stoping the LAN automation, on which interfaces i can see the reserved pool IP address on PnP agents and will these switches having Loopback configuration and IP address, If yes please confirm which IP address will get and from which pool.